2 point-to-point configuration – Comtech EF Data turboIP v4.0 User Manual
Page 100
![background image](/files/778857/content/doc100.png)
turboIPv4.0
Revision 6
Sample Configuration
MN/TURBOIP.IOM
7-2
7.2 Point-to-Point
Configuration
Internet
WAN
LAN
Remote Site
WAN
LAN
15
M
b
p
s
20
48
k
bp
s
Hub Site
15
M
b
p
s
20
48
k
b
p
s
This configuration is a typical example where turboIPs’ are used to maximize the TCP
throughput in a Point-to-Point system. Note the turboIPs’ are placed so that all TCP traffic
between the Remote and the hub must pass through the turboIP. The following table defines the
configuration settings for each turboIP.
Configuration Parameter
Hub turboIP
Remote turboIP
WAN Transmission Rate
15 Mbps (equal to the TX
data rate of Hub modem)
2048 kbps (equal to the TX
data rate of Remote modem)
Congestion Control
Rate Pacing
Rate Pacing
Selective Acceleration
No Selective Acceleration Rules are required. Rules could be
added to prioritize or set BW limits on any type of traffic.
Route Table
No Route Table entries are required. Routes could be added
to allow remote access from outside of LAN subnet.