Comtech EF Data turboIP v4.0 User Manual
Page 24
Advertising
turboIPv4.0
Revision 6
Fail to Wire
MN/TURBOIP.IOM
2-4
2.4 N
O
F
AIL TO
W
IRE
B
OARD
I
NSTALLED
If no FTW board is installed as part of the turboIP, then the last four characters of the
Unit ID on the Upgrade page will read “00FF”. Without a FTW board installed in the
turboIP this feature is unavailable. The unit will detect the absence of FTW capability
and not be able to switch into “wire” mode during possible failures or reboots.
The absence of a FTW board can be verified by looking at the Unit ID on the HTTP
interface and the CLI interface as shown below.
Advertising