Comtech EF Data turboIP v4.0 - Manual (Page 101)

turboIPv4.0 Revision 6
Sample Configuration MN/TURBOIP.IOM
7-3
7.3 Point-to-MultiPoint Configuration
Broadcast
Outbound
Internet
WAN
LAN
204
8 k
bp
s
15
M
b
p
s
Remote Site 1
Remote Site 2
Remote Site 3
Hub Site
20
48
k
b
p
s
15
M
b
p
s
15
M
bp
s
15 M
bps
20
48
kb
p
s
20
48
k
bp
s
20
48
k
b
p
s
20
48
k
b
p
s
WAN
LAN
WAN
LAN
WAN
LAN
In the Point-to-Multipoint configuration, a single turboIP is used at the Hub to accelerate TCP
traffic to three Remote sites, each with a turboIP. The following table defines the configuration
settings for each turboIP.
Configuration Parameter Hub turboIP Remote turboIP (1, 2, & 3)
WAN Transmission Rate 15 Mbps (equal to the TX
data rate of Hub modem) 2048 kbps (equal to the TX
data rate of Remote modem)
Congestion Control Rate Pacing Rate Pacing
Selective Acceleration
No Selective Acceleration Rules are required. Rules could be
added to prioritize or set BW limits on types of traffic. Rules
could also be added to set a priority or BW limit on traffic to a
particular site.
Route Table No Route Table entries are required. Routes could be added
to allow remote access from outside of LAN subnet.