Comtech EF Data turboIP v4.0 - Manual (Page 59)

turboIPv4.0 Revision 6
Configuring turboIP ™ MN/TURBOIP.IOM
4–31
A DMIN A CTIONS
Function Select Description
Restore Defaults E Restore Factory Default settings (SSH/CLI Only function)
Reboot turboIP R Manual Reboot
Shutdown turboIP S Manual Shutdown
Upgrade turboIP U Upgrade turboIP SW – See Section
Reset System Time T Time reset (SSH/CLI Only function)
Change Password P Change current Password (SSH/CLI Only function)
Add User A Add new User account (SSH/CLI Only function)
Delete User D Delete User account (SSH/CLI Only function)
Multiple Users – Up to five user accounts are supported via the Web, SSH and Serial
interfaces. Account authentication will be done using passwords. Passwords shall be
required to follow the complexity requirements specified in the Password Complexity
section below.
User Accounts - There shall be two levels of user accounts: Administrator and Normal
User. There must always be at least one Administrator account.
The first Administrator account must be created through the Configuration Wizard. If
only one Administrator account exists, the user will not be able to delete the account. An
error message will be displayed if there is an attempt to delete the Administrator.
Usernames - must be at least five and no more than thirty-one alphanumeric characters
in length.
Administrator Functions - The Administrator shall be able to change passwords, add
and delete users only through the SSH and Serial interfaces. Normal users will not be
able to see or edit these settings.
When adding user accounts, the Administrator must specify if the account is an
Administrator or Normal User.
The option to change usernames through the Serial interface will no longer be available.
To accomplish this, the Administrator can delete the user account and then add it back in
with a new username. If the Administrator user tries to add more than the maximum
number of user accounts, an error message will be displayed.