Flowserve Byron Jackson Type M - Manual (Page 13)

® Byron Jackson Double Mechanical Seal Submersible Pumping Unit • 1042.293/9 • June 04
Page 13 of 68
Store pumping unit
NOTE The following description refers to
pumps without auxiliary carriers.
Should the pump be delivered on an
auxiliary carrier, refer to the pump
manual for storage and shipping
instructions.
Store the pumping unit as follows:
•
Motor:
Preferably vertically
Filled with oil
•
Pump bowl assembly with rubber bearing
bushes:
Vertically
•
Pump bowl assembly with other than rubber
bearing bushes:
Preferably vertically
DANGER
Horizontally stored motors and
pump bowl assemblies must be se-
cured against rolling.
Vertically stored motors and pump
bowl assemblies must be secured
by appropriate means in this stor-
age position to prevent tipping over.
•
Power cable:
Leads protected from moisture
NOTE Do not bend power cable during
storage.
Maintenance during storage
•
Storage up to four weeks
At the beginning and end of the storage pe-
riod: Carefully check the motor to be sure
there are no signs of oil leakage.
•
Storage between 1 and 24 months
Maintenance of the motor, every 6 to 8 weeks:
1. Remove the motor shipping cap (112) at
the motor.
2. Turn the motor shaft several times by
means of a wrench.
3. Mount the motor shipping cap (112) to
the motor.
Maintenance of the pump, every 6 to 8 weeks:
1. Remove the discharge housing and the
non-return valve for the pump shaft.
2. Turn the pump shaft several times by
means of a wrench.
4. Mount the discharge housing and non-
return-valve to the pump.
•
Storage for over 24 months
After a storage of more than 24 months, we
recommend a complete visual inspection at
our main factory or at your nearest Flowserve
representative.
Shipping
Ship motor and pump bowl assembly
•
in non-airtight protection film
•
in wooden box or similar transport packaging.
2.4 Recycling and end of product life
At the end of the service life of the pumping unit or
its parts, the relevant materials and parts should be
recycled or disposed of using an environmentally
acceptable method and heeding local regulations.
If the product contains substances which are harm-
ful to the environment, these should be removed
and disposed of in accordance with local regula-
tions. This also includes the liquids and or gases in
the "seal system" or other utilities.
DANGER
Make sure that hazardous sub-
stances are disposed of safely and
that the correct personal protective
equipment is used.
The safety specifications must be in
accordance with the local regula-
tions at all times.
Hazardous substances in the pumping unit are
•
Motor oil