FSR FLEX CONTROL BUILDER TRAINING MANUAL - Manual (Page 107)

LIT1368E Flex Training Manual
Page | 107
32600 LIT1368F
SET/Clear GPIO
The Flex LT 200 and LT-300 have four General Purpose I/O ports. Each port can be set as
Open, Close or it can be Pulsed. These are TTL level low current ports and should only be
used with compatable devices. If higher voltage and / or current switching is required, then
the GPIO ports should he used to control compatible relays such as FSR K10-D relays.
When this action is selected the following window appears:
By default, all ports are set to Output. To change port settings, click the +General Purpose
in the Project Tree and select a port to change.