FSR FLEX CONTROL BUILDER TRAINING MANUAL - Manual (Page 5)

LIT1368E Flex Training Manual
Page | 5
32600 LIT1368F
The above screen is available from the ABOUT screen of the program. Please refer back to this often
and check for Program, Library, and Firmware updates.
The first time the Flex Control Builder is started, you should check for program updates, and you
must click on Get Library Update to download all of the available library files.
TRAINING
REQUIREMENTS
This is a hands-on exercise to familiarize the technician with the entire FLEX system. Before you
begin it is important to have the proper functioning equipment. You will need the following: FLEX
LT-200 Control Panel, Flex Control Builder Software, Laptop or Desktop Computer with a Serial
Port or Functioning USB to Serial Converter Operating System, or an IP connection on a network
within the same domain as the Flex panel: Windows 8, Windows 7, or Vista.
IMPORTANT NOTE: Prior to the exercise be sure the Flex Control Builder is properly installed and
communication between the computer and the FLEX panel is tested, and fully functioning.
INTRODUCTION
In this module of the FLEX training program we will follow a step by step process to create a Project
and download it to a Flex control system. A Project defines how the Flex panel will look as well as
how it will behave.
The first step to creating a project is to define what devices are being used, how they will be
connected together and determine what capabilities of a device we want the Flex to control.