FSR FLEX CONTROL BUILDER TRAINING MANUAL - Manual (Page 63)

LIT1368E Flex Training Manual
Page | 63
32600 LIT1368F
The next type is Press / Release . When the button is pressed, the actions in the Press
Action window are executed. When you remove your finger from the button, the actions in
the Release Actions window are executed. You do not have to populate a Press / Release
button with Press and Release actions. When a Press / Release button is pressed, the
alternate graphic is shown until the button is released.
The third type of button is a Press / Hold / Release button . In this case the Press actions
occur when you press the button. If you hold the button for more than ½ second, the Hold
actions occur repeatidly until you remove your finger from that button. At that point, the
Release actions occur. It is not necessary to populate the Press, Hold and Release areas.
They can be used in any combination to achieve the desired effect. When a Press / Hold /
Release button is pressed, the alternate graphic is shown until the button is released.
The final button type is a Toggle Button . A Toggle Button is one that you press once to do
something and press again to do something else. In this case, the First Press Actions occur
the first time that the button is pressed. When the button is pressed again, the Second Press
Actions occur. Press the Toggle Button Tab to see this type.
Note: Whichever style is selected Toggle or Press / Hold / Release, the style selected last
will be the style saved to the project. That is to say that if you selected a press action, filled
in some actions and then decided to make it a Toggle style button and fill in actions there,
the Toggle will be the one saved to the project. There is no need to delete the actions in the
press window as long as the toggle was last selected before going on to the next button to
add actions to.