FSR FLEX CONTROL BUILDER TRAINING MANUAL - Manual (Page 116)

LIT1368E Flex Training Manual
Page | 116
32600 LIT1368F
allowing the user to set the date and time directly .
Flex Connect
Connecting to the Flex unit and utility functions including cloning are performed through the Flex
Connect button.
Default IP Address
All Flex Units are shipped from FSR with an IP address set to 192.168.5.70
If your network is not 192.168.5 you may change the Flex panels’ IP address from the touch
screen on any panel with firmware of 2.16 or later by pressing on any part of the
background graphic and holding for 10 seconds. A window will open that will allow you to
change the IP address of the panel directly. To communicate to panels with an earlier
firmware version you will need to change your computers’ IP setting or connect to the
serial port on the front or the serial port 2 on the back of the Flex.