GAI-Tronics 12389-001 NOVA PA/GA Systems S.M.A.R.T. Modules - Manual (Page 11)

Pub. 42004-674L2H
NOVA P UBLIC A DDRESS S YSTEMS - S.M.A.R.T. M ODULES P AGE 9 of 24
f:\standard ioms - current release\42004 instr. manuals\42004-674l2h.doc
12/13
6. Set Line Test Interval: When all the lines have been programmed, and the results have been stored,
select the interval for the stand-alone self-commanded test. To do this, move the rotary line-select
switch to the time value according to Table 2 below.
Table 2.
Time Switch Position
15 minutes 8
30 minutes 9
1 hour A
2 hours B
6 hours C
8 hours D
12 hours E
24 hours F
7. Then press and hold the button for 3 seconds until the fault LEDs begin flashing. The test interval is
now stored. N OTE : The factory-default test interval is 1 hour.
8. Remove the JU1 programming jumper.