Start-up display, Boot-up error code definitions, Code definitions – GAI-Tronics CommandPLUS Series Desktop Console Installation and Service Manual User Manual
Page 38: Card suite software version, Firmware version – host – dsp – display cpk
Console Diagnostics CommandPLUS Series Desktop Console Installation and Service Manual
12/10 34
Start-Up Display
Boot-Up Error Code Definitions
The following error codes are displayed automatically upon boot-up:
Master– 00
If anything other than 00 is displayed for the master error, contact GAI-Tronics field service.
Slave– 00 00 00
00 = OK
01 = Slave not present
02 = Slave malfunction
04 = Slave malfunction
06 = Slave malfunction
Code Definitions
Any options that are installed are identified by the option codes in the display. They are as follows:
ENC = Paging Encode
SLT = STAT-ALERT (MDC1200)
PMC = Positive Mode Control
DEC = DTMF Decode
SUP = Supervisory Control
CTI = Telephone Interface
MLS = Multi-Line Select
MFQ = Multi-Frequency
CDC = DC Option
E&M = E&M Option
CTH = Full Duplex Phone Board
CARD Suite Software Version
Version x.x.x
Firmware Version – Host – DSP – Display CPK
Firmware Version: CPK xx Host xx Mast xx