GAI-Tronics CB193-001 Call Boxes - Manual (Page 22)

Pub.: 43004-031E
Model CB193-xxx, CB194-xxx, and CB195-xxx RF Call Boxes Page 21 of 52
f:\radio products-current release\43004\43004-031e\43004-031e.doc
11/12
To properly charge the back-up battery (if required), the 40404-060 power supply (included in the kit)
must be set for 15.0 V dc output. This output can be adjusted at the voltage adjustment potentiometer
labeled ADJ. Refer to Figure 2 for wire connections.
Figure 3. Power Supply Wiring Connections
PC Programming
All RF Call Boxes require the use of the CARD Software application (included on the XAC4000A
Programming Bundle CD) and the XAC0004A Programming Cable for the Call Box non-default settings.
The Model CB193-001, CB193-002, CB194-001, CB194-002, CB195-001 and CB195-002 RF Call
Boxes additionally require the use of the 19101-024 RF Module Programming Kit. This kit includes a
separate cable and software for programming the RF Module’s operating frequency and TPL/DPL code.
Refer to the programming instructions on page 42 of this manual.
The CARD Suite Software application is used to program the Call Box PCBA. The ANI code,
minimum/maximum user timeouts, sleep enable/disable, “go-ahead” tone, volume, DTMF transmit level,
and stand-by times are all configurable through the CARD Suite Software application.