GAI-Tronics CB193-001 Call Boxes - Manual (Page 46)

Pub.: 43004-031E
Model CB193-xxx, CB194-xxx, and CB195-xxx RF Call Boxes Page 45 of 52
f:\radio products-current release\43004\43004-031e\43004-031e.doc
11/12
6. Select Model from the Menu, then Product Information to display the Product Information Box.
Select the appropriate transceiver model number from the Model Name drop-down menu and select
OK
. N
OTE : The FPU does not always verify the model number of the connected radio.
Failure to select the proper model number could cause programming the radio for an incorrect
model, rendering it inoperable.
7. While still in the Zone Information Screen, enter the appropriate radio system information (TX/RX
Freq., Decode/Encode data, power setting, etc.).
N OTE : “High” power setting can only be used for external antenna applications
8. Select Edit from the Menu and perform the following:
Optional Features
• Common Page 1 tab - Change the “Minimum Volume” setting to 15.
• Common Page 2 tab - Check the “Firmware Programming” box.
If Fleetsync is utilized, change the PTT ID Type from DTMF to Fleetsync.
• Conventional tab - Decrease Squelch Level to 4.
• Close window.
Key Assignments
• “Top/Side/Front tab”
- Set the “S” switch to “Squelch Level”.
- Set the “A” switch to “Low Transmit Power”
- Set the “B” switch to “Zone Up”
- Set the “C” switch to “Zone Down”
• Close window.