Gasboy CFN Series Diagnostic Manual - Manual (Page 391)

CFN Islander
12/26/02 13-23
ISLANDER II (SITE CONTROLLER II C05852) CPU PCB
This CPU PCB controls all activity in the Islander. The CPU PCB:
•
processes all Islander data
•
communicates to all CFN equipment via the RS-485 lines
•
communicates on four RS-232 ports
•
provides diagnostic LED’s
•
provides a manual reset switch
•
requires Memory PCB C05849
•
requires Dsite V4.0 or higher
•
requires OS version 2.0C or greater
Layout
See section 3 of this manual for a detailed view, LED indicator functions, switch and jumper
settings, and connector pinouts for this board. Any jumper settings specific to the Islander II are
shown below.
Jumpers
K1 and K2, Port 1 and Port 3 Configuration Jumpers for the Islander II