Reset transaction file – Gasboy FMS KE200 User Manual
Page 33
MDE-4465A KE200 Key Encoder/Maintenance Terminal Operation Manual · October 2007
Page 27
Configure Maintenance Transactions (1000 FleetKey only)
KE200 Setup - Standalone
To reset Transaction Pointer, proceed as follows:
1
From the “CONFIG MAINT TRANS” display, press ENTER. The system displays the
following:
MAINT TRANS MENU:
RESET TRANS POINTER
2
Press ENTER. The system displays the following:
RESET TRANS POINTER:
?
3
Type the number at which you want transactions to start and press ENTER.
Reset Transaction File
Use “RESET TRANS FILE” to reset the maintenance transaction file.
To reset Transaction file, proceed as follows:
1
From the “CONFIG MAINT TRANS” display, press ENTER. The system displays the
following:
MAINT TRANS MENU:
RESET TRANS POINTER
2
Press F1 until the system displays the following:
MAINT TRANS MENU:
RESET TRANS FILE
3
Press ENTER. The system displays the following:
ARE YOU SURE?
<ENT>=YES
<CLR>=NO
4
Press ENTER to reset the file. The system displays the message “COMMAND
COMPLETED”.