Highgear PulseWare Duo - Manual (Page 26)

25
english
CHRONOGRAPH MEMORY PLAYBACK –
PULSEWARE DUO
Pulseware Duo heart rate monitors are
equipped with a memory that gives you
detailed information playback of your
completed workout.
1. In CHRONOGRAPH mode with the
CHRONOGRAPH STOPPED PRESS &
HOLD MODE key. The first two screens
are summaries of entire workout.
2. Upper line displays TIME IN, ABOVE and
BELOW HEART RATE TARGET ZONE
(example HI 3:08, Lo 3:58, In 12:56)
Lower line displays TOTAL TIME OF
WORKOUT.
PRESS the MODE key to advance to next
screen.
3. Upper line displays TOTAL TIME FOR
WORKOUT followed by NUMBER OF
LAPS and AVERAGE LAP TIME (example:
06.03:58 = 6 laps, 3 min. 58 sec. Average
per lap).
Lower line displays MAXIMUM HEART RATE with PERCENT
OF MAXIMUM HR (in small numbers, lower right) followed by
AVERAGE HEART RATE for workout with percent of maximum
(in small numbers, lower right).
PRESS the MODE key to advance
to next screen.
NOTE: If heart rate is above or below target zone the number
will blink on and off.
4. LAP DETAIL is displayed in descending order (last lap completed
to first).
Upper line blinks to display LAP NUMBER followed by LAP
TIME.
Lower line displays AVERAGE HEART RATE FOR LAP and
PERCENT OF MAXIMUM.
PRESS the MODE key to advance to previous lap.
5. You may exit the Memory Playback at any time by PRESSING &
HOLDING the MODE key.
OPERATING THE WATCH
Pulseware_DuoMax_HighGear.indb Sec1:25 Pulseware_DuoMax_HighGear.indb Sec1:25 2/17/06 12:34:13 PM 2/17/06 12:34:13 PM