Highgear PulseWare Duo - Manual (Page 32)

31
english
REPLACING THE TRANSMITTER BATTERY – DUO
The Pulseware Duo features a wireless heart rate transmission
system. This system uses a heart rate transmitter, which is worn,
on your chest. Like the watch unit, the transmitter is powered by a
CR2032 3v Lithium battery. Under normal conditions you can expect
to get approximately 700-800 hours of transmitter use with a fresh
battery.
1. Using a coin that closely fits the slot in the battery door located
on the back of the transmitter, turn the battery door counter
clockwise until the door comes free of the transmitter body.
2. Take care not to damage the O-ring seal for the battery
compartment and carefully remove the old battery.
3. Place a fresh battery in the battery compartment with the positive
(+) side facing up.
4. With the O-ring in the proper position, place the battery door over
the opening and tighten it down by using a coin and turning in a
clockwise direction.
5. If the O-ring has been damaged, replace it before reinstalling
the battery door. Most jewelers and watch shops should have
replacement O-ring seals.
NOTE: Extreme care should be taken when replacing the
battery to ensure the unit remains fully water resistant. Failure
to properly replace the battery and correctly seal the unit may
cause the unit to become damaged and may void the warranty.
CARE AND MAINTENANCE
Pulseware_DuoMax_HighGear.indb Sec1:31 Pulseware_DuoMax_HighGear.indb Sec1:31 2/17/06 12:34:18 PM 2/17/06 12:34:18 PM