Ivoclar Vivadent IPS e.max ZirPress - Manual (Page 41)

41
Observe the following notes for the Stain and Glaze firing:
– Conduct the Stain and Glaze firing on a honey-combed firing tray using the stipulated firing parameters.
– Remove restoration from the furnace after completion of the firing cycle (wait for the acoustic signal of the furnace).
– Allow the objects to cool to room temperature in a place protected from draft.
– Do not touch the hot objects with metal tongs.
– If adjustments are required after Glaze firing (e.g. contact points), they may be applied using IPS e.max Ceram Add-On
(see page 46).
Firing parameters for the Stain and Glaze firing
IPS e.max Ceram on IPS e.max ZirPress B S t
➚
T H V 1 V 2 L
Cut-Back and Layering Technique °C/°F min. °C/°F/min °C/°F min. °C/°F °C/°F °C/°F
Stain firing 403/757 6:00 60/108 725/1337 1:00 450/842 724/1335 450/842
Glaze firing 403/757 6:00 60/108 725/1337 1:00 450/842 724/1335 450/842
Completed IPS e.max ZirPress restoration pressed partially reduced and veneered with IPS e.max Ceram
The dental lab work was performed by
Jürgen Seger, Ivoclar Vivadent, Schaan/Liechtenstein
C
u
t-
B
a
ck
Te
ch
n
iq
u
e