Ivoclar Vivadent IPS Eris for E2 User Manual
Page 28
28
The distance between the objects to be pressed and the paper ring/ring gauge must be at
least 10 mm. This applies to all the above schematics.
Observe a distance of at least 3 mm between the
individual objects.
Observe a distance of at least 10 mm between the paper
ring and the objects to be pressed.
Remove excess separating material.
Consider the direction of low of the ceramic material when
positioning the sprues. For small objects invest a phantom
sprue together.
Ring gauge
If the crown is viewed from the proximal, the longer side of the object (usually the buccal surface) points outwards. Additionally, the flow of the ceramic material must be observed.
The attachment points of the sprues must be rounded. Observe an angle of 45 to 60 °.
at least 10 mm
at least 10 mm