Ivoclar Vivadent IPS Eris for E2 - Manual (Page 36)

36
Always work with water cooling to avoid
overheating of isolated areas.
Fit the framework to the die
Remove the spacer prior to fitting the pressed object to the
die. Be careful when fitting the object. In case of interfering
irregularities, cover the die with a thin layer of a suitable
control paste. Then, fit the object on the die again. Carefully
remove interfering irregularities with a fine diamond. Use
finishing diamonds or fine emery disk, to adjust the margins,
if necessary.
IPS Empress Die Material
Control die
Fabricate a die according to the shade information supplied
by the dentist (shade selection), using the IPS Empress Die
Material Kit. This die enhances the shading of the
restorations.
The IPS Empress Die Material is used to enhance the shading of the restoration.
Coat the inner surfaces of the ceramic object with IPS Empress Die Material Isolating Liquid.
Apply the corresponding Die Material to the inner surface of the restoration, using the IPS Empress Die
Material Condenser.
Insert a die holder into the material. Here, a premolar is shown.
The Die Material is cured with a light-polymerization device
(e.g. Targis Power).