Ivoclar Vivadent Telio Lab - Manual (Page 20)

Checking the cut-back Application of SR Composiv Individualization using Telio
Stains Removal of the inhibition layer
– The inihibition layer is dabbed off using a sponge.
– Now the reduced and stained restoration is replaced in the silicone key and positioned on the pre-
viously wetted and isolated model.
Second injection (Telio Lab Transpa Incisal)
Same procedure used in the first injection
Polymerization in a water bath
(e.g. Ivomat ® IP3)
Pressure (bar/psi) Temperature (°C/°F) Time (min)
2–6/29–87 40–50/104–122 15
20
The respective light-curing Telio components are pre-polymerized to ensure that they stay in place and to
be able to apply a further layer. However, final polymerization of the entire restoration is always required.
Polymerization device Manufacturer Pre-polymerization Polymerization
Quick Ivoclar Vivadent 40 s (SR Composiv 60 s) ––
Lumamat ® 100 (Targis ® Power
Upgrade)
Ivoclar Vivadent Exclusively use Quick for pre-polymerization.
11 min
(program P 2)
Spectramat ® Ivoclar Vivadent 5 min (Telio Stains 2.5 min) 5 min