Ivoclar Vivadent Telio Lab - Manual (Page 30)

In this processing technique, the restoration is
polished and incorporated immediately after milling
in the CAD/CAM system. In the process, the surface
lustre is achieved by manual polishing. This pro-
cessing technique is very efficient and leads to an
esthetic result quickly and easily.
After milling in the CAD/CAM device, the resoration
is separated from its holder with a fine tungsten car-
bide bur or a diamond separating disk and fitted on
the model.
Finishing
Use (fine) cross-cut tungsten carbide burs to finish
Telio CAD blocks.
Fully anatomical fabrication and
final polishing
Telio CAD restoration after milling
Telio CAD on the working model
Note
Remove any possible white spots on the restoration that have developed during milling in the
CAD/CAM device using a tungsten carbide bur.
30