Leprecon LP-612 - Manual (Page 10)

9
Manual Mode
The LP600, in addition to being a powerful memory console, can also be used as a simple two-
scene preset board. This allows an untrained operator to immediately start using the board, and
learn it's more advanced features as time permits.
To set the LP600 to manual mode, press the 'preset' menu button. The 'page' LED will light.
Press the 'down' arrow until the display shows:
now
next
time
stack
step
rate
pattern
ch ase
preview
bump
preset
record
m o de
on on on
page
run
612
This indicates that the preset memories are off. The 'preset on' LED will be turned off.
X and Y Preset Scenes
The most basic control of the LP600 console is provided by the rows of faders for the two manual
scenes, labeled "X" and "Y." Each X and Y pair of faders controls a single console channel, which
may be connected to one or more dimmer channels. The green output LED above each channel
indicates the channel's relative intensity.
Crossfader
The Manual Crossfader, just to the left of the Y scene faders, is used to fade from the top manual
(X) scene to the lower(Y) manual scene. With the fader at the top position, the board output will
be set by the levels on the X scene faders. If the crossfader is moved to the bottom position, the
levels on stage will be set by the position of the Y scene faders.