Leprecon LP-612 - Manual (Page 20)

19
When the record key is pressed, the LED’s located next to the bump buttons will begin to flash
along with the record LED. This is to indicate that the buttons are ready to select a preset to be
recorded.
When a bump is pressed, the scene is recorded. The preview LED is lit momentarily (along with
the page LED), and the display verifies the number of the preset which was just recorded.
Illegal or impossible record commands will result in an error indication on the display:
If the record button is pressed when presets are disabled (page -- ), the error message will be
momentarily displayed. If the selected preset was in "Page-Freeze" mode, then the display shows
a flashing error for a couple of seconds, and the preset is not recorded. The display then reverts
to the page number.
While in the Record mode, scenes may be entered in any order into the LP600. Once recording is
finished, press the "Run" mode button to return to run mode.