Leprecon LP-612 - Manual (Page 29)

28
Pre-programmed Chases
The standard Chases can be run immediately without recording steps, but cannot be altered.
These Chases are selected by setting the Chase pattern display to positions 1 through 4. The four
standard Chases have the following effects:
1) Straight
A single channel on, advancing sequentially from 1-2, 2-3, and so on until step 6 loops
back to channel 1.
2) Reverse
Same as Chase 1 except begins with channel 6, and proceeds to light lower channel
numbers until 1 is reached. The next step loops back to channel 6.
3) Zig-Zag
A ten step Chase that starts with only channel 1 up, and advances sequentially until
channel 6 is lighted. Step 7 starts the Chase back down from channel 6 to 5, and it
proceeds back down to channel 1, when the pattern repeats.
4) Straight 12 channel
Same as Chase 1 except advancing sequentially from 1 to 12, when the loop repeats.
Recording New Chases
The Chaser section of the LP600 allows for seven custom Chases to be programmed by the user.
Each of these patterns can consist of up to twenty-four steps, each consisting of any combination
of channels. These programmable Chases are available on patterns 5 through 11.
To record a custom Chase:
1) Set the pattern display to one of the patterns 5 to 11.
2) Move the 'Chase' fader to zero. The Chase cannot be running while steps are
recorded.
3) Press the 'Chase' menu button a second time to enter 'step' mode.
4) Press the 'record' button.
5) Set the channels of the Chase step using the bump buttons or X scene faders.
6) Press the 'up' key to advance to the next step.
7) When finished, press the 'run' key to end programming.