Leprecon LP-612 - Manual (Page 24)

23
Recording Stack Scenes
Recording into the Stack places a stage look in the cue selected as 'next'. In the example, this
would be Cue #1. To select another cue, use the display up and down keys.
Set up the stage look by using the X channel faders or any available presets. Press the 'record'
button. The red LED next to the switch, will begin to blink.
Cues can be entered in sequence simply by setting scenes and pressing the 'record' button to
record each cue. At any time, any cue number from 1 to 50 can be set and recorded. The
sequence will advance from that point. For example, 'next' could be set to 10 This would be done
by pressing the display up key until the number "10" appears on the display. The next time 'record'
is pressed, Cue #10 will be recorded. The Cue number will automatically advance, and the next
cue would be 11.
When recording is finished, return to Run mode by pressing the "Run" button. The Record and
Select LED’s will stop flashing and the bump buttons will return to normal operation.
To record Stack Presets:
1) Press the 'stack' menu button to display 'now' scene.
Use the 'down' key to set now to '--'
2) Press the 'stack' menu key again to light the 'next'LED.
3) Use the display up and down keys to select a cue number of 1 through 50.
4) Set levels on stage using manual channels or Presets.
5) Press the 'record' key once. The 'record'LED will begin to blink.
6) Press 'record' again to memorize the cue. The 'next' cue number will advance.
7) Continue setting and recording cues.
8) Press 'run' to end recording.