Leprecon LP-612 - Manual (Page 21)

20
Preset Playback
Once scenes have been recorded into the Preset Memory faders on the LP600, they are
immediately available for use. It is not necessary to leave the record mode to check or playback
the memory.
With the master fully up, bringing up the fader for a memory scene will output the scene to the
stage. Any number of faders can be up at one time, the scenes 'pile on' in a higher takes
precedence fashion.
Previewing Presets
From the preset page display, pressing the Presets menu button again will set the console to the
Preview mode. This will be indicated by the 'preview' LED. The preview mode is available only if
the 'preset on' LED is lighted, which indicates a page number of 1 through 4 is selected.
now
next
time
stack
step
rate
pattern
ch ase
preview
bump
preset
record
m o de
on on on
page
run
612
In Preview mode, the green output level LED’s no longer represent the on-stage levels. The LED’s
now show the channel levels as stored in the selected preset scene. The LED’s next to the bump
buttons are steadily lit, indicating the bumps function as presets selects.
The first time this mode is entered after startup, the preset number 1 is selected. This number can
be changed by pressing the up or down arrow keys or by pressing the bump button below the
preset to be previewed.