Leprecon LP-612 - Manual (Page 16)

15
To erase Stack Cues in the LP600:
1) Press the "stack" menu button in the upper left corner of the board. Repeat key press until the
"now" LED is lighted.
2) Press the "down" arrow until the label "CL", indicating CLear, appears on the display. The red
record LED will begin to blink.
3) While the LED is blinking, press the "record" key.
4) While the display is blinking, press 'record' again to clear all presets.
5) The LP600 will verify the operation by displaying “SE” (Stack Erase) for a few seconds.
To erase Chases in the LP600:
1) Press the "Chase" menu button in the upper left corner of the board. Repeat key press until the
"pattern" LED is lighted.
2) Press the "down" arrow until the label "CL", indicating CLear, appears on the display. The red
record LED will begin to blink.
3) While the LED is blinking, press the "record" key.
4) While the display is blinking, press 'record' again to clear all presets.
5) The LP600 will verify the operation by displaying “CE” (Chase Erase) for a few seconds.