Microsonic LCA-2 - Manual (Page 43)

Visualisation of measurements Page 43 of 51
V ISUALISATION OF MEASUREMENTS
S
ELECTING THE MODE
 Click
only for mic-.../M30, lcs and lpc:
Please notice that the sensor in conjunction with LinkControl performs ultrasonic measurements only
under the Measurement menu. When the visualisation is invoked no ultrasonic measurements take place
for some seconds. Also the repetition rate is greatly reduced during visualisation mode. You are allowed
to visualise measured distances on an installation or machine under operation using LinkControl only, if
you have made sure that no harmful situation for man and machine may occur when doing so. When in
doubt you have to power down the installation or machine during visualisation with LinkControl.
Before visualising the measured distances the parameters in the input masks has to be identical
to the ones of the connected sensor. Read out the parameters from the connected sensor first.
You can select out of three different modes:

Numeric presentation

Graphic presentation

Measurement writer