NavCom StarFire Satellite Change Rev.G User Manual
Page 10
Troubleshooting Guide – StarFire™ Satellite Changes Mar ‘12
Rev. G
x
Release - March 12
View
D3
LBM Software v3.0 or Later and GPS Software Version 3.2.9 or Later.
LBM DSP Status
Check StarFire signal C/No Value which should be above 0dB (>9dB is typical at
NavCom’s office in Southern California)
The C/No value varies based on the distance between the StarFire satellite and the receiver.
Define Satellite
o
Select
Receiver
Setup
StarFire
Define Satellite
o
Check Enter User-Defined Satellite
o
Set the Frequency(KHz) to Satellite ID per Table 4 for the appropriate area of operation
Table 4: LBM v3.0 Satellite ID’s For New Satellites
Location Net Satellite
ID Frequency
(KHz)
New
Service
on-air
54W
2
446
1,539,842.5
2/15/2012
178E
2
678
1,539,862.5
2/15/2012
143.5E 1
644
1,539,892.5
1/11/2012
98W
1
403
1,539,872.5
1/18/2012
64E
2
564
1,539,872.5
2/15/2012
25E
1
526
1,539,862.5
2/22/2012