NavCom StarFire Satellite Change Rev.G - Manual (Page 4)

Troubleshooting Guide – StarFire™ Satellite Changes Mar ‘12
Rev. G iv Release - March 12
Select Receiver Messages NCT output from the menu bar. The NCT Binary Messages window
opens.
o Ensure that these default messages are scheduled for output:
86 – On Change
A0 – On Change
AE – Every 600 Seconds
B1 – On Change
o Schedule this message for output:
30 – On Change
Schedule messages for output that are pertinent to the
StarFire L-Band Module (LBM).
o Select Receiver Setup StarFire
Configure Message Output. The LBM
Messages window opens.
o Schedule these messages for output:
D0 – Every 600 Seconds
D1 – Every 600 Seconds
D2 – On Change
D3 – On Change
D5 – On Change