Lbm v1.5 – NavCom StarFire Satellite Change Rev.G User Manual
Page 3
Troubleshooting Guide – StarFire™ Satellite Changes Mar ‘12
Rev. G
iii
Release - March 12
IF the new software identified in Table 2 is installed, there is no need to follow the instructions which follow.
Based on the table above, identify the software in your unit and refer to the appropriate section below.
LBM v1.5 Instructions
Please follow the procedure below to manually tune the StarFire receiver to the new frequency. This
instruction applies to LBM v1.5 and earlier.
This instruction assumes that the receiver is currently licensed for and tracking StarFire satellite signals. If
after completing this instruction, the receiver is not tracking StarFire signals, please refer to t
.
View
AE – Version Information
View
D0-LBM Identification Block