NavCom StarFire Satellite Change Rev.G - Manual (Page 24)

Troubleshooting Guide – StarFire™ Satellite Changes Mar ‘12
Rev. G xxiv Release - March 12
Check StarFire signal C/No Value which should be above 0dB (>9dB is typical at
NavCom’s office in Southern California)
If the receiver is moved from one StarFire region to another, the receiver will not automaticly tune to
the new receiver frequency. When this occurs, repeat the initial steps with the appropriate new
frequency and ID.
Observe the operational mode and correction age
o dGPS mode: StarFire Dual RTG or StarFire Dual GNSS
This coverage map shows the coverage after all frequencies are changed:
Does not include the footprint for the 15.5W satellite
Back to 1
st
page