NavCom StarFire Satellite Change Rev.G - Manual (Page 5)

Troubleshooting Guide – StarFire™ Satellite Changes Mar ‘12
Rev. G v Release - March 12
View D3
o LBM Software v1.5 or Earlier and GPS Software Version 3.1.17 or Earlier
LBM DSP Status
Check StarFire signal C/No Value which should be above 0dB (>9dB is typical at
NavCom’s office in Southern California)
The C/No value varies based on the distance between the StarFire satellite and the receiver.
Set the Alternate Satellite
o Select Receiver Setup StarFire Alternate Channel
o Set the Alternate Channel to based on the Table 3 below:
Table 3: LBM v1.5 Channel ID’s For New Satellites
Location Net Channel ID Frequency (KHz) New Service on-air
143.5E 1 29786 1,539,892.5 1/11/2012
98W 1 29745 1,539,872.5 1/18/2012
25E 1 29725 1,539,862.5 2/22/2012