NavCom SF-2110 Rev.C - Manual (Page 49)

SF-2110 User Guide – Rev. C
Communication Port Connectivity
There is no default control port on the receiver.
Establish communications via Bluetooth or a data
cable:
9
Setup Bluetooth communications via either
StarUtil-2110 or a third party software/utility.
9
Connect the supplied Positronic 9-Pin connector
of the serial cable (P/N 94-310260-3006LF) to
Port A or Port B of the SF-2110. Connect the DB9
end to the control device.
‡
Figure 18 shows a common configuration with
the control device connected to Port A and an
auxiliary device connected to Port B for data
logging.
‡
Some devices may require an additional
adapter. The receiver is configured as a DCE
device.
Figure 18: Communication Port Connections
* Consult Release Notes on the NavCom web site for availability.
3-47