Nortec GS Series - Manual (Page 56)

53 | GS Series Installation
Drain Pump Replacement
Drain the unit completely. If the pump is broken use the auxiliary drain out port.
Shut off electrical power to the appliance.
Remove front and right doors.
Remove wiring connections to the pump.
Remove hoses attached to the pump.
Reverse above procedure to re-install.
NOTE: To avoid water spillage (some water will be left on the tank bottom after manual draining) use shop
vac to remove left over water.
Figure 40: Fill Valve Replacement
Figure 41: Drain Pump Assembly
Fill Box Replacement
Take the humidifier out of operation.
Undo the screw (Phillips screwdriver) and remove the right
side panel.
Remove hose clamps on the fill box connections and pull off
the hoses.
Undo the two nuts securing the fill box to the face of the tank,
then remove the fill box.
Re-installation is carried out in the reverse sequence. Make
sure the hoses are correctly secured with the hose clamps.
Figure 42: Fill Box Replacement