RGBLink VSP 516S User Manual - Manual (Page 96)

6. System Setup and Operation
How to Realize Single Image Switching
VSP 516S User Manual 96
How to Realize Single Image Switching
Boot the system default CV1 to the current input source, if need seamless
switching other source such as DVI, push DVI button, OLED module show
as follows:
CV1 button light turns off after pushing DVI button. DVI button light is on if
the DVI signal is effective and stable. And if the DVI signal is invalid or no
input, DVI button light will flash.
The same method can switch the signals among CV2, CV3, SVID, YPbPr,
VGA, SDI and DP.
Note
Only cut switching is supported among the switch
of CV1, CV2 and CV3.
SOURCE SELECT:
>DVI