Seaward Europa Pac Plus - Manual (Page 22)

Storing Test Results
16
If the memory is full when attempting to store a result the primary
display will show STOR with the secondary display flashing Full.
Memory Options
There are three options available:
• Recall result
• Delete last result
• Delete all data
• Memory
available
Move the rotary switch to Data Look Up, use the cursor buttons to
select a memory option.
Recall Result
Use the cursor buttons to select rCL. Press the SELECT button to
select this option. The two digits in the top right hand corner indicate
appliance location. The primary display shows the measured value.
The secondary display shows the test limit. The type of test is
indicated by the test icon.
The cursor buttons are use to move through the memory locations.
On initial entry into recall result the last saved memory location is
displayed.
If an attempt is made to recall a result outside of the saved memory
range a message is displayed. Attempting to recall below the first
saved result will cause bot to be displayed. Attempting to recall above
the last saved result will cause the toP to be displayed.
Delete Last Result
Use the cursor buttons to select CLr. Press the SELECT button to
select this option. The two digits in the top right hand corner indicate
memory location. The primary display shows the measured value.
The secondary display shows the test limit. The type of test is
indicated by the test icon. Only the last result in memory can be
deleted.