SVSi N2000 Series - Manual (Page 32)

Page 32 N2000 Series User Manual www.svsiav.com
Chapter 2. Installation Switching and Scaling Options
SWITCHING AND SCALING OPTIONS
SVSi Encoders and Decoders make up a true AV matrix solution. In other words, one input can go to any or
all outputs.
Both Encoders and Decoders have internal scaling capabilities. Keep the following in mind:
• The input of an Encoder is the video and/or audio signal going into the Encoder.
• The output of an Encoder is the network stream.
• The input of a Decoder is the network stream.
• The output of a Decoder is the digital video and/or audio being transmitted out to the display
device.
Seamless Switching
The N2000 Series supports seamless switching capability if the scalers in the Encoders are all set to the
same resolution and refresh rate. If the scalers are off, all of the sources must have the same resolution and
refresh rate.
To get streams onto a Decoder, use the Video Matrix tab to route video from an Encoder to a Decoder. This
works seamlessly if the previously mentioned settings are true. All you have to do is click the common cell on
the matrix, and click the Take button. See
Figure 2-12 for an example.
Figure 2-12. Seamless Switching Using the Video Matrix
Enabling this cell causes the Conference Rm Decoder to listen
to the Conference Rm Encoder.
Click Take to
apply
changes.