Teac DR-1 - Manual (Page 4)

4
TASCAM DR-1
Since this unit uses an SD card for recording and
playback, you must insert an SD card into the unit
before use. You can use 64 MB–2 GB SD cards and 4
GB–32 GB SD HC cards with this unit.
Please see the TASCAM web site (www.tascam.com)
for information about cards that have been tested with
the DR-1.
About SD cards
Press the inserted SD card in gently and it will
disengage from the unit so that you can completely
pull it out.
CAUTION
Do not remove the SD card during recording or playback,
or when the unit is connected to the computer by USB.
Inserting the SD card
Removing the SD card
2–Preparation
The SD card slot and the USB connector are under the
cover on the left side of the unit.
Press the cover down in the direction of the arrow to
open it. Insert the included SD card in the SD card slot
and push it until it clicks fully into place.
Inserting a new card
The following pop-up screen appears if you insert a
new card in the unit.
Press the ¥/π key to format the card so that it can be
used with this unit.
When formatting finishes, the Home Screen appears.
CAUTION
Formatting an SD card erases all files that are on it. Make
certain that you have copied any files that you want to
save from the card before formatting it.
Other cases that require formatting
• The above “
FORMAT ERROR
” screen also appears
if you install an SD card that was formatted by a
device other than the DR-1. Reformat the card to use
it with this unit.
• The following pop-up screen appears if a system file
or other crucial file was accidentally erased from the
SD card when used with a computer
In either case, press the ¥/π key to reformat the card.
TIP
Always make backup copies of important files as soon as
you can.