Teac DR-1 - Manual (Page 9)

TASCAM DR-1
9
3–Part Names and Functions
Right side panel
Left side panel
y OUTPUT VOLUME (+, –) keys
Use these keys to adjust the signal level output
from the /LINE OUT jack. The volume level
appears on the display during adjustment.
u MIX BALANCE (–, +) keys
When the Input Setting Screen’s
MONITOR
item
is set to
ON
, use these keys to adjust the volume
of the playback signal that is mixed with the
input signal. The playback volume appears on the
display during adjustment. Use the + key to raise
the volume and the – key to lower the volume.
When
MONITOR
is set to
OFF
, “
MONITOR
OFF
” appears on the screen and these keys have
no effect.
i SETTING key
Press this key to open the Input Setting Screen
where you can select the input, make
INT/MIC1
IN
settings and turn
MONITOR
ON and OFF.
o INPUT volume
Use this to adjust the input signal level of the
built-in microphone, the MIC 1 IN jack and the MIC
2 IN jack. This does not affect the input signal level
of the LINE IN jack
p /LINE OUT jack
Use this to connect with headphones or the
line input jack of an amp or other equipment.
Depending on the
MONITOR
setting and recorder
operation status, this outputs the input signal, the
playback signal or a mix of both signals.
a DC IN 5V jack
Connect a TASCAM PS-P520 AC adapter
(purchased separately) to this jack.
s SD card slot
Insert an SD card into this slot. (See “About SD
cards” on page 4.)
d USB port
Use the included USB cable to connect with a
computer USB port. (See “Connecting with a
computer” on page 15.)
CAUTION
Please connect the unit directly to a computer without
using a USB hub.
f POWER key
Press and hold this key to turn the unit’s power ON
and OFF.
g HOLD switch
Slide this to the left to turn the hold function ON.
All keys are inoperative when hold is ON.