Teac MD-CD1MKIII - Manual (Page 31)

TASCAM MD-CD1MKIII
31
Deleting a programmed track
1 During STOP mode, use the skip button to select
the track for deletion.
The track number will be shown in the display.
2 Press the DEL/CLR button.
NOTE
Right after STOP, if the DEL/CLR button is pressed, the
last track programmed will be deleted.
Adding a track to the program
1 During STOP mode, using the skip buttons, skip
to the programmed track before the position you
wish to add a track.
The track number should be shown on the display.
Example:
To add a new 3rd track (between 2nd and 3rd), display
the 3rd track (“3p”) of the program.
2 Use the number buttons to input the track number
of the track to be added.
3 Press the ENT/YES button on the remote control.
NOTE
Right after STOP, if the number of the track to be •
added is input, and the ENT/YES button on the remote
control is pressed, the track will be added to the end of
the program.
To add a track to the program by front panel operation,
•
use the MULTI JOG dial to select the track number,
then press the dial.
Erase a CD or MD program
Insert the CD or MD for which you want to erase a
program into the deck.
1 Set the playback mode to Program.
2 Select “CLEAR PROG?” from the CD or MD menu.
Sure?
appears.
If the playback mode is not Program, Can't Sel!
appears and you cannot select the option.
3 Press the MULTI JOG dial (or YES key) on the unit or
the ENT/YES key on the remote control.
The program is erased. When the erasing is complete,
Complete
appears.
NOTE
The program is also erased if all tracks in the program are
erased using the DEL/CLR button.
Program limitations
With an MD, if the Group playback mode is on, •
programs that include more than one group cannot be
created.
With data CDs, if the Directory playback mode is on,
•
programs that include more than one directory cannot
be created.
The same track may be repeated in a program.
•
When 99 CD tracks (or 25 MD tracks) are entered into a •
program, if you attempt to add a track,
PGM Full!
will be displayed, and no more tracks can be added.
Saving program data
Programs of up to 100 discs including CD and MD can •
be retained.
For data CD, a single program uses double the usual
•
capacity, so the maximum number retainable will be
lower.
If a created program exceeds the capacity, other
•
programs will be automatically erased starting from
the oldest.
Programs on the currently inserted disc can be erased
•
using the menu.
CDs are distinguished by the total number of tracks (or
•
files) and total recording time (total capacity in the case
of data CD).
MDs are distinguished by the total number of tracks
•
and recorded time.
Discs with the same total number of tracks and the
•
same total recording time (total capacity in the case of
data CD) are regarded as identical.
Random playback
In this mode, the deck will play back all the tracks on
the disc in completely random order, regardless of track
number.
1 During stop mode, press the P. MODE button on
the remote control until
RANDOM
is indicated on
the display.
NOTE
You can also use the
PLAY MODE?
option in the PLAY
sub-menu of the MD and CD menus to set the Random
Playback mode.
2 Press the PLAY button.
Random playback starts. Playback stops when all the
tracks have been played once.
NOTE
Even when the power is turned off, the deck will remain in
RANDOM mode.
7 – CD and MD Playback