Teac MD-CD1MKIII - Manual (Page 49)

TASCAM MD-CD1MKIII
49
Data communication settings
By connecting a PC through its RS-232C terminal to
the MD-CD1MKIII through its CONTROL I/O (RS-232C)
terminal, the two units can be linked for data exchange.
Use the following options on the SERIAL sub-menu of the
CD menu to perform their respective settings.
BAUD RATE
Sets the communication speed of the keyboard.
4800/9600/19200/38400 bps can be selected.
Default: 9,600
LENGTH
Communication word length can be set to either 7 or 8
bits.
Default: 8 bits
PARITY
Communication parity can be set to NON, EVEN or ODD.
Default: NON
STOP BIT
The data stop bit can be set to either 1 or 2.
Default: 1
Viewing service data
You can view service data via the following items in the
SYSTEM submenu of the CD menu.
CD P_TIME
The total CD playback time is shown.
MD P_TIME
The total MD playback time is shown.
MD R_TIME
The total MD recording time is shown.
Initializing all data
You can reset all data to initial default settings.
1 Make sure that no disc is loaded in the MD or
CD player. Select the
F_PRESET
? option on the
SYSTEM sub-menu of the CD menu.
The display indicates
Sure?
.
2 Press the MULTI JOG dial (or YES button) on the
unit or the ENT/YES button on the remote control.
All data will be initialized to the default settings.
CAUTION
Do not turn off the power to the unit until the •
Complete
indicator on the display disappears.
If the settings are initialized, all the programs retained •
for each disc will be erased.
14 – Data settings/Service Data