Teo 8810 ISDN Phone - Manual (Page 22)

18 Tone Commander 8810 User Guide
UNANS VA ON REDIAL
Using Voice Announce
The Voice Announce feature may be used to provide hands-free call
announcing of screened calls when your phone is on-hook and idle.
Incoming calls that meet specific predefined criteria that have been set
up by your telephone installer can be answered automatically by the
speakerphone. The microphone can be automatically disabled for
announcing only, or enabled to allow two-way conversations. You can
enable or disable Voice Announce at any time.
Enabling/Disabling
When the phone is idle, the display will show the current Voice
Announce state.
The Voice Announce state is shown only if Voice Announce
keys have been set up by your telephone installer.
Press the softkey beneath the VA display to enable or disable
Voice Announce.
Receiving Voice Announce Calls
Calls selected for voice announcing will be answered automatically if
your phone is on-hook and idle. You and the caller will hear a double
beep if your microphone is muted, or a single beep if your microphone
is enabled. The call will disconnect when the caller hangs up. After the
call has been answered, you can pick up the handset for a private
conversation, turn muting on or off, press the
SPKR key to disconnect,
and perform other normal call operations. Voice Announce is
disabled when you are on an active call with the handset, headset,
or speakerphone.
CAUTION – If Call Announce is enabled for a calling directory number,
the caller should not transfer calls unscreened (blind) to your
telephone, otherwise the transferred call will be answered using Voice
Announce.