Verilink PRISM 3002 (34-00277) Product Manual - Manual (Page 2)

ii
Copyright Notice
Copyright © 1999 Verilink Corporation. All rights reserved.
This document does not create any express or implied warranty about Verilink or about its prod-
ucts or services. Verilink’s sole warranty is contained in its product warranty. The end-user docu-
mentation is shipped with Verilink’s products and constitutes the sole specifications referred to in
the product warranty. Verilink has made reasonable efforts to verify that the information contained
herein is accurate, but Verilink assumes no responsibility for its use or for any infringement of pat-
ents or other rights of third parties that may result. The customer is solely responsible for verifying
the suitability of Verilink’s products for its use. Specifications are subject to change without notice.
Manual reorder # 34-00277
2
nd
Edition, May 1999
Trademarks
Verilink is a registered trademark Verilink Corporation.
Any named products herein are trademarks of their respective companies.
FCC Requirements
This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to Part 15 of FCC Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency energy and if not installed and used in
accordance with the instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference in which
case the user is required to correct the interference at his own expense.
Shielded cables must be used to ensure compliance with the Class A FCC limits.
Modifications to this unit not expressly approved by the party
responsible for compliance could void the user’s authority to
operate the equipment.
This device complies with Part 15 of the FCC rules. Operation is subject to the following two
conditions:
• This device may not cause harmful interference.
• This device must accept any interference received, including interference that may cause undesired
operation.
For Users of 1.544 Mbps Service
The following instructions are provided to ensure compliance with FCC Rules, Part 68.
1 All direct connections to T1 lines must be made using Part-68-compliant plugs and jacks.
2 The telephone company may require the following information when applying for leased-line
facilities.
Port ID: P/N FSG 3XX2/4
REN/SOC: 6.0 F
FIC: 04DU9-BN (SF)
04DU9-DN (B8ZS and SF)
04DU9-IKN (ESF)
04DU9 -ISN(B8ZS and ESF)
USOC: RJ-48C
3 If the unit appears to be malfunctioning, it should be disconnected from the telephone lines until
you learn if the source of trouble is your equipment or the telephone line. If your equipment
needs repair, it should not be reconnected until it is repaired.