Verilink PRISM 3301 (34-00239.5) Product Manual - Manual (Page 13)

2
I
NSTALLATION
This chapter contains information and instructions required to install the PRISM
3301. Included are initial inspection procedures, mounting instructions, port
connectors, switch settings, and powering information.
Unpacking and
Inspection Upon reveiving this shipment, inspect the shipping container and contents. If the
contents of the shipment are incomplete or, if there is mechanical damage or
defect, notify Verilink Customer Service. If the shipping container or cushioning
material is damaged, notify the carrier and Verilink immediately and make a
notation on the delivery receipt that the container was damaged (if possible, obtain
the signature and name of the person making delivery). Retain the packaging
material until the contents of the shipment have been checked for completeness
and the instrument has been checked both mechanically and electrically.
Supplied
Materials The PRISM 3301 product is shipped from the factory with the following items.
✦ Two BNC cables (male/male)
✦ AC power cord
✦ HSSI data cable (male/male)
✦ Supervisory cable
✦ T3 terminal adapter kit
✦ Rack mount hardware for 19-inch equipment racks
✦ Reference manual
✦ Configuration guide
For specific applications, additional cables and adapters may be required. The
interface requirements of any application may be met by using the appropriate
cable. Standard cables and Verilink ordering numbers are listed on page 47. If
necessary, contact Verilink for assistance in cable selection.
After unpacking and confirming the contents, place the unit on a flat surface,
allowing enough space to verify the hardware configuration. Also verify that the
power receptacle on the rear panel is compatible with your power source.