Verilink PRISM 3301 (34-00239.5) Product Manual - Manual (Page 24)

16 C HAPTER 4: T ERMINAL I NTERFACE
If a password has been previously established, enter the correct password to
continue the session. The password is case-sensitive. After entering a valid
password, the unit responds with the message:
Password verified: privilege level is X.
The unit can now be configured using the ASCII interface. For an explanation of
the privilege levels, see the SET ADMINISTRATION PASSWORD command on
page 19.
To establish a password, see SET ADMINISTRATION PASSWORD command on
page 19.
Configuration
Commands The ASCII terminal interface provides a command line mode for configuring and
monitoring the PRISM 3301. These commands are Set, Get, Query, Test, Reset,
and Reboot.
To see a quick reference list of available keywords, press Shift+?.
Set Commands The SET commands configure the PRISM 3301 system parameters. Each
command is followed by one or more keywords with each keyword being
separated by a space.
SET NET LBO
This command sets the line build-out (LBO) for the DS3 interface. The LBO on
the network interface sets the strength of the signal sent into the network by the
TXPORT 3301. Correct setting of this parameter ensures proper operation of both
the DTE and the network. An incorrect setting can result in unreliable operation
and for interference between user services.
0 = 0 to 150 feet
150 = 150 to 300 feet
300 = 300 to 450 feet
SET NET YELLOW-X-BIT
This command sets the representation of the yellow alarm. Both of the X bits can
be set to 0 or 1 to represent the yellow alarm. The choices are 0 or 1.
SET NET AIS PATTERN
This command sets the presentation of the AIS alarm. AIS can be presented in two
forms: one is the standard DS3 blue alarm which alternates 1s and 0s (1010…);
the other form is all 1s used by MCI.
The choices are BLUE or FAO. Select BLUE for a standard DS3 blue alarm pattern
of alternating 1s and 0s; select FAO (Frame All Ones) for a pattern of all 1s.
SET NET AIS RX-STUFFING
This command sets the AIS Rx-Stuffing option. The choices are ON or OFF.
✍