Set administration circuit, Set administration application, Set audible – Verilink PRISM 3301 (34-00239.5) Product Manual User Manual
Page 28: Set datalink eic, Set datalink lic, Set datalink fic, Set datalink uic, Set datalink path-message, Set datalink idle-message, Set datalink test-message
20
C
HAPTER
4: T
ERMINAL
I
NTERFACE
SET ADMINISTRATION CIRCUIT
This command sets the circuit number (up to 24 alphanumeric characters) used for
network management purposes. (optional)
SET ADMINISTRATION APPLICATION
This command sets the Application ID number (up to 24 alphanumeric characters)
used for network management purposes. (optional)
SET AUDIBLE
This command enables or disables the audible alarm. When enabled, this setting
can be overridden with the ACO switch (S1-4 on page page 9).
SET DATALINK EIC
This command initializes the Equipment Identification Code for the near-end unit.
This command accepts up to ten alphanumeric characters and can include
embedded spaces if the string is enclosed in double quotes.
SET DATALINK LIC
This command initializes the Location Identification Code for the near-end unit.
This command accepts up to 11 alphanumeric characters and can include
embedded spaces if the string is enclosed in double quotes.
SET DATALINK FIC
This command initializes the Frame Identification Code for the near-end unit. This
command accepts up to ten alphanumeric characters and can include embedded
spaces if the string is enclosed in double quotes.
SET DATALINK UIC
This command initializes the Unit Identification Code for the near-end unit. This
command accepts up to six alphanumeric characters and can include embedded
spaces if the string is enclosed in double quotes.
SET DATALINK PATH-MESSAGE
This command initializes the Path Identification Message for the near-end unit.
This command accepts up to 38 alphanumeric characters and can include
embedded spaces if the string is enclosed in double quotes.
SET DATALINK IDLE-MESSAGE
This command initializes the Idle Signal Identification Message for the near-end
unit. This command accepts up to 38 alphanumeric characters and can include
embedded spaces if the string is enclosed in double quotes.
SET DATALINK TEST-MESSAGE
This command initializes the Test Signal Identification Message for the near-end
unit. This command accepts up to 38 alphanumeric characters and can include
embedded spaces if the string is enclosed in double quotes.