Watson-Marlow 5O5XY Robot - Manual (Page 9)

Part 3: Setup
Accessing the setup mode
This section illustrates how various parameters such as language used and
serial communication speed are set up upon receipt of a new machine. It
also shows that this procedure need only be carried out once, as all
parameters are stored, even when the unit is switched off.
Setup mode is accessed by holding down the soft key, which is positioned to
the extreme left of the three keypad softkeys, whilst the power is switched on
at the rear of the machine. When the key is released the display will show
the following message:
S E T U P P R O G R A M M E
E N T E R P A S S W O R D
Enter the system password (1212) the display will show the following
message:
S E T U P P R O G R A M M E
C O U N T R Y M E M O R Y N E X T
Selecting a language
Press the key beneath the "country" option on the display. The display will
show the following message:
E N G L I S H N E X T A C C E P T
Press the NEXT button to step through each available language option.
Press ACCEPT to select the desired option and return to the setup menu.
Clearing memory
NOTE. This should only be necessary after maintenance work or after a
software upgrade. This operation will erase all settings stored in the
module.
At the setup menu press the MEMORY button. The display will show the
following message:
E R A S E M E M O R Y
A C C E P T Q U I T
Press the ACCEPT button to erase all memory locations, or the QUIT button
to cancel the operation and return to the setup menu. After pressing the
NEXT button, the display will show:
9