Westermo TDW-33 - Manual (Page 14)

6618-3202 14
%Fn –V23 Speed selection
Supported by: TDW-33 TD-36 TD-36 485 TR-36 TR-36B
The direction and speed of forward and backchannels for V23C modulation are set with
this command.
Syntax:
AT%F<n>
Parameters:
<n>
1: Selects 75Tx/1200Rx
2: Selects 1200Tx/75Rx
3: Selects 1200Tx/1200Rx. (Default)
Command example Possible responses Note
AT%F<n> OK The command is valid
and accepted
ERROR Otherwise
&Fn – Restore Factory Configuration
Supported by: TDW-33 TD-36 TD-36 485 TR-36 TR-36B
Description:
The modem loads factory default configuration (profile).
A configuration (profile) consists of a subset of S-registers.
Syntax:
AT&F<n>
Parameters:
<n>
0: Load factory default settings for all commands except Westermo specific commands.
1: Load factory default settings for all commands except Westermo specific commands.
2: Load factory default for Westermo specific commands.
Command example Possible responses Note
AT&F<n> OK The command is valid
and accepted
ERROR Otherwise
S register: None